CAN Bus Fieldbus DB9 to M12 Interface Connector Cable 35 Degree

Description

Introduction:

CAN Bus Fieldbus DB9 to M12 Interface Connector Cable features a 9-pin female D-sub connector interface and two M12 A Code 5 Pin Connectors. The D-sub connectors have 4-40 UNC mounting screws. Its 35-degree angled design allows for flexible installation in tight spaces. To connect the gateway component to CANopen, you need one CAN-Bus Connector Cable D-Sub 9 Pin to M12. Premier Cable P/N: PCM-0635

Specification：

Pin Configuration:

The connector carry a second D-Sub as a PG interface for programming or diagnosis purposes. And the M12 connector comes with the standardized A-coding. It has 5 pins. In the context of CANopen or CAN Bus, typically,

Pin 1: CAN H(CAN High)
Pin 2: CAN L (CAN LOW).
Pin 3: Ground (GND)
Pin 4: Power+ (Vcc, +24C, etc.)
Pin 5: Power- (oV, Ground)

The CAN High (CAN_H) and CAN Low (CAN_L) pins are used for the differential signaling of the CAN Bus communication protocol. The Ground (GND) pin provides a reference ground connection, while the Power + and Power - pins supply power to the connected devices. 

Pls Note: The actual pinout is based on the specific drawing.

Drawing: